Screens and Graphics • Range text boxes: Enter the minimum and maximum values for the specified tag(s). If a tag's actual value goes outside of its range, then the value is ignored and the limit is used instead. • Size (%) text boxes: Enter the minimum and maximum values for the size of the object. The minimum value can be as low as 0% (making the object effectively invisible), and the maximum value can be as high as you want. 100% is the original size of the object when you draw it in the Screen Editor , so 200% would be double the original size, and so on. During runtime, the object's size is proportional to the tag value within its range.
For example, if Size (%) is 0 to 100 and Range is 0 to 10 , then each increment in the value will increase the object size by 10%. This is true for both Height and Width. • Reference drop-down lists: Select a reference point to determine the directions in which the object will change size. The following table shows how your selections for Height and Width work in combination: ROTATION ANIMATION On the Graphics tab, in the Animations group, click Rotation to add the animation to an Open Polygon , Closed Polygon , Line , or Linked Picture object. Double-click on the object to open the Object Properties dialog. Object Properties:
Rotation animation Use this dialog to specify the following parameters: • Tag/Expression field: Enter a Tag name or expression to associate with the Rotation animation. The value of Tag/Expression determines the actual rotation of the object; as the value changes, so does the amount of rotation. • Range area: Enter the Minimum and Maximum values allowed for Tag/Expression . Values less than the minimum and greater than the maximum are disregarded. • Rotation (degrees) area: Enter the Start and End positions (in degrees) of the object. The actual rotation is proportional to the value of Tag/Expression within Range . An object can rotate up to 360 degrees, and it rotates clockwise by default.
Tip: For example, a Rotation animation has the following settings: Minimum is 0, Maximum is 100, Start is 0, and End is 180. If the current value of Tag/Expression is 50 (i.e., halfway between Minimum and Maximum), then the actual rotation of the object is 90 degrees (i.e., halfway between Start and End). A value of 25 is equal to 45 degrees, a value of 75 is equal to 135 degrees, and so on. • Reference combo-box: Select one of the following as a pivot point on which to rotate the object: • Left-Top : Upper-left corner of the object. • Left-Bottom : Lower-left corner of the object. InduSoft Web Studio Page 209 LEFT CENTER RIGHT TOP CENTER BOTTOM