omron — Align

Screens and Graphics Note: Alternatively, right-click on an object and select Move to front from the object's shortcut menu. Move Backward and Move Forward IWS assigns a unique identification number (ID#) to every object on the screen. These ID#s always start at zero and range up to the total number of objects on the screen. You can click on an object to display its ID# in the status bar . IWS uses ID#s to determine whether an object displays in front of or behind another object on the screen. Objects with lower ID#s display behind objects with higher ID#s.Use the following object layer tools to move selected object(s) behind or in front of another screen object(s). Note:

You can use these tools only with a single selected object or group of objects. You cannot use these tools with multiple objects selected. Also, if you select a group of objects and move them the behind or in front of another object, the selected group of objects maintain their original display order. Click the Move backward tool to move the selected object or group one layer below the next object on the screen. (Alternatively, right-click on the object and select Move backward from the shortcut menu.) IWS assigns the selected object the next available ID# less than the object behind which it was moved.

Click the Move forward tool to move the selected object or group one layer above the next object on the screen. (Alternatively, right-click on the object and select Move forward from the shortcut menu.) IWS assigns the selected object the first available ID# greater than the object in front of which it was moved. Group and Ungroup Tools Use the following tools to group and ungroup two or more selected objects. Note: All objects with animations and Group of Symbols objects (which includes most symbols and library objects) have multiple Object Properties dialogs and properties.

You can use the drop- down list on the Object Properties dialog ( Properties on the Graphics tab of the ribbon) to access these different dialogs and properties. Click the Group tool to combine multiple objects into a single object to facilitate object selection and manipulation. (You can access each part of the group in the Object Properties dialog.) Note: Alternatively, you can right-click on an object and select Group from the object's shortcut menu. Click the Ungroup tool to separate a grouped object into its individual components. Note: Alternatively, you can right-click on an object and select Ungroup from the object's shortcut menu. Tip:

A complex grouped object can consist of several sets of grouped objects (known as subgroups ). Consequently, you may find it necessary to ungroup all of the subgroups to completely ungroup a complex object. Align, Center and Distribute Tools When you select a series of objects (two or more), you can align those objects based on the location of the last object selected. As you select objects, solid handles display on the last object selected, and the handles on all previously selected objects become empty (unfilled) boxes. Note: In all of the figures provided, the rectangle represents the last object selected. Use the following alignment tools to align a series of objects.

Page 212 InduSoft Web Studio