Data Logging and Display We need to create a data source in order to access to the text file. Click on the New… button, specify the Data Source name MyTextFile and then click Create . You should see the following information now: Setting X Axis field to 0 On the X Axis field we need to indicate which column in our text file represents the X Axis. In our example we are using column zero, so enter 0 for this field, then click Data Source Settings… . The following window will display:
Selecting the text file If you have copied the text file to the project folder, you only have to specify the file name, otherwise, enter with the complete path where the file is located (use the browse button as needed). Click OK on this window and OK again to finish the data source configuration and close the Data Source configuration Window. Now we need to define our Y1 and our Y2. They will be represented by points on our Trend Control. Double-click on the Trend Control again to access the Object Properties window and then click on Points… . Your next step is to define the points according to the following figure: InduSoft Web Studio Page 257