Installation Given the nature of Windows Embedded devices, each combination of OS version and device processor has its own build of CEView. All of these builds are located in the following directory: […]\InduSoft Web Studio v7.0\Redist\ The build for your specific device is located in the following directory: […]\InduSoft Web Studio v7.0\Redist\ version \ processor \ …where: • version is the version of the operating system on the device where CEView will be installed: • The \WinCE 5.0 folder contains the files for Windows CE and Windows Mobile 5.0 or later; and • processor is the processor used by your Windows CE device.
We provide a CEView runtime for every processor that is currently supported by the Windows CE operating system (e.g., Pocket2003-ArmV4, ArmV4i, x86). For more information, consult the manufacturer's documentation for the device. • The \WinEmbedded folder contains the files for Windows XP Embedded and Windows Embedded 7. To install the files on your device, use the Remote Management tool in the development application. Installing via TCP/IP (Ethernet) Tip: We recommend using TCP/IP whenever possible. To install CEView on a Windows Embedded device via a TCP/IP (Ethernet) connection: 1. Make sure your Windows Embedded device is connected to your network. 2. Turn on the device.
The Remote Agent dialog should open automatically. If it does not, then you must manually install the file CEServer.exe on the device. The file is located here: […]\InduSoft Web Studio v7.0\Redist\ version \ processor \CEServer.exe There are different ways to install the file — for example, you can use Microsoft ActiveSync (for Windows 2000 and Windows XP) or Windows Mobile Device Center (for Windows Vista) to communicate directly with the device or you can map the device as a shared folder on your PC. For more information about copying and executing files, consult the manufacturer's documentation for the device. 3.
In the Remote Agent dialog, click Setup and then configure the communication settings for the device's network connection. In particular, note the IP address of the device. 4. Start the development application on your PC. 5. On the Home tab of the ribbon, in the Remote Management group, click Connect . The Remote Management dialog is displayed: Remote Management dialog 6. In the Target System group-box, select Network IP and then type the IP address of the device. 7. Click Connect to establish a connection between the development application and the device. If the conncection is successful, then the device's specifications will be displayed in the Platform text- box.
Page 30 InduSoft Web Studio