Downloading to a Remote Device If you click Advanced , the Serial Advanced Settings dialog is displayed. Serial Advanced Settings dialog You can use the parameters on this dialog to control the flow of data between your target and development stations: • Baud Rate : Select a baud rate from this drop-down combo box. • Control RTS : Select (check) this to use a "Request to Send" control, where IWS sends an RS-232 signal from the transmitting station to the receiving station requesting permission to transmit. • Control CTS :
Select (check) this to use a "Clear to Send" control, where IWS sends an RS-232 signal from the receiving station to the transmitting station to indicate the receiving station is ready to accept data. When you finish setting these parameters, click OK to close the Serial Advanced Settings dialog. • TCP/IP : Enable this button to establish a TCP/IP connection to the development station. Tip: For better performance, we recommend using a TCP/IP connection instead of a Serial Link connection. 3. When you are finished, click OK to close the Setup dialog, but leave the Remote Agent program running in the remote workstation.
Continue to " Configuring the Development Station ." InduSoft Web Studio Page 395