Licensing Installing or Upgrading a CEView License (Remotely) Tip: You can purchase some Windows Embedded devices with a CEView softkey license already installed. Ask your software vendor about this possibility. You can register a CEView license on your Windows Embedded device by using IWS to send the license to the device. This works for both hardkey and softkey licenses. To install a new (or upgrade an existing) CEView license (remotely): 1. Perform the four first steps described in the previous section . 2. In the Setup dialog, specify the Device Connection type by clicking (enabling) the Serial Port or TCP/IP radio button.
(If you enable Serial Port , you also must select a port from the combo-box list). Click OK to close the dialog. 3. Connect your development workstation to the Windows Embedded device using either a serial or TCP/ IP link. 4. Run the IWS development application. 5. On the Home tab of the ribbon, in the Remote Management group, click Connect . The Remote Management dialog is displayed: Remote Management dialog 6. Specify a target system by clicking one of the following radio buttons in the Target System : • Network IP , and then type the IP address into the field provided • Serial Port , and then select a port from the combo-box list provided • Microsoft ActiveSync Note:
You cannot upgrade a CEView hardkey license via Microsoft ActiveSync. 7. When the Connect button becomes active, click the button to connect to the Windows Embedded device on which the Remote Agent is running. (If you select Network IP , then you must also enter the IP address in the text box provided.) Tip: TCP/IP links provide better communication performance than serial links. The Status field must display the following message: Connected to CEView version 8. Select the Embedded License tab to see which license settings are currently installed on your Windows Embedded device. 9.
From the License Codes section, copy the information from the Site Code field and send it to your software vendor. • Your software vendor will send you a Site Key that corresponds to this Site Code. Type this site key into the Site Key field. • Click the Send button to send the code to the Remote Agent running on the Windows Embedded device. InduSoft Web Studio Page 49