Appendix: Built-in Scripting Language strPhonebookEntryOrModem The Phonebook Name, Modem Name, or Direct Connection Name used to make the connection. The numType parameter specifies which of these methods is used. strUserName The Username to use for logging on. strPassword optStrDomain The Password to use for logging on. Optional The domain name to specify when logging on. strPhoneNumber The phone number to dial (used only when the parameter numType=1). Returned value Notes The operating system's RAS Server executes the dial-in for Windows PC stations automatically. Examples See also :
FindModem() DialUpToCE Runs the DialUpToCE program, which sends the information necessary to CERasSvr.exe calls back to the Server. Note: This function is not supported on Windows 7. InduSoft Web Studio Page 607 0 OK: dialing started −1 Error: INDRAS.DLL not found −2 Error: INDRAS.DLL damaged −3 Error: invalid number of parameters (minimum=5) -4 Invalid value for the numType parameter (0 or 1) -5 Invalid value for the strPhonebookEntryOrModem parameter (string) -6 PhoneBook or Modem does not exist -7 PhoneBook or Modem is in use -8 Depends of the numType parameter: • If numType = 0: Could not read properties from PhoneBook. • If numType = 1:
More than 1000 connections are enabled at same time. -9 Unable to create a temporary PhoneBook. Tag Name Expression Tag DialUp( 0, "OfficeDialup", "Guest", "Password" ) Tag DialUp( 1, "USRobotics SportsterFaxModem", "HR12378", "HRPass", _ "15125554321" ) Tag DialUp( 2, "DirectDial", "Rberton", "MyPassword", "156.48.25.0") Function Group Execution Windows Embedded Thin Client DialUpToCE Dial-up Asynchronous Supported (see note) Not supported Supported