en Installation and connection During dishwashing heat energy is used to heat up the washing water and dry the mineral. During the drying phase moisture from the interior of the dishwasher is stored in the mineral and heat energy is released. The heat energy is blown out into the interior of the dishwasher with dry air. This speeds up and im- proves drying. Zeolith drying therefore saves a great deal of energy. Tip: To avoid impairing Zeolith drying performance, do not position table- ware parts directly in front of the in- take opening or the blow opening of the Zeolith container.
Do not position heat-sensitive table- ware parts directly in front of the blow opening of the Zeolith container. → "Appliance", Page 14 5 Installation and con- nection To ensure proper operation, connect the appliance to the power and water supply correctly. Observe the spe- cified criteria and the installation in- structions. 5.1 Scope of supply After unpacking all parts, check for any damage in transit and complete- ness of the delivery. If you have any complaints, contact the dealer who sold you the appli- ance or our Customer Service. Note: The appliance has been tested at the factory to check it is in working order. It is possible that water has left marks on the appliance.
These marks will disappear after the first wash cycle. The delivery consists of the following: Ў Dishwasher Ў Operating instructions Ў Installation Instructions Ў Further information documents Ў Installation material Ў Steam guard plate Ў Salt filling aid funnel Ў Mains cable Ў Quick reference guide 4.4 Efficient Dry The appliance door opens automatic- ally during the drying phase. This en- sures a particularly economical dry- ing result. For best drying results wait until the end of programme before unloading the tableware. The programme has ended when the display shows "0h:00m".
If automatic door opening is deactiv- ated, energy consumption increases and the drying phase is usually shortened. → "Overview of the basic settings", Page 34 5.2 Installing and connecting the appliance You can position your built-under or integrable appliance in a fitted kit- chen between wooden and plastic walls. If you subsequently install your dishwasher as a free-standing appli- ance, you must stop it from tipping over, e.g. by screwing it to the wall or 12