Delta ISPSoft — 20.3.4.1 Introduction of a Data Exchange Table

ISPSoft User Manual 20-46 Column Description Serial Number (#) The data exchange groups in the data exchange table in the PLC Link Table Editor window are numbered. Users can set 16 data exchange groups or 32 data exchange groups, depending on the model selected. Station Addr. Indicate the station address for data exchange group. The same station address can contain multiple sets of slave station from different sections. Besides, the station address 0 represents an undefined slave station, and is not a broadcast station address. R/W R: The master station reads the data in devices in a slave station. W: The master station writes data into devices in a slave station.

Master Device Data The range of devices which are used in the master station is indicated. : The master station writes data into devices in a slave station. Slave Device Data The devices which are used in a slave station are indicated. If a slave station is a user-defined Modbus device, the devices used will be represented by hexadecimal addresses. Length A data length is indicated. A length indicates the number of devices used. Status Users can decide whether to involve a data exchange group in data exchange. If a data exchange group is set incorrectly, the data exchange group will not be involved in data exchange.

If a data exchange group is not involved in data exchange, the related data will be on a gray ground. Device Type The device types shown are consistent with the device names shown in the working area in NWCONFIG. If a slave station address is assigned to a network module, the name of the PLC to which the network module is connected will be shown. Besides, if a slave station is undefined, it is unknown.