ISPSoft User Manual If the users click , a new piece of data will be added to the table. A piece of data is composed of two parts. The left part of the data in the figure below indicates that the data demanding node AH-01 will store the data demanded in L0 in itself, and the right part of the data in the figure below indicates that the data supply node AH-02 will supply the data in L0 in itself. The steps of setting a data exchange group are as follows. (1) Select a node number in the # cell for the data demanding node. After the users select a node number, the PLC name corresponds to the node number will be appear in the Device Name cell for the node number.
If the users select a specific node number rather than All Nodes on the node list, the data in the table will be related to the specific node number selected, and the fixed node number in the # cell for the data demanding node will be the specific node number selected on the node list. (2) Select a device type in the Register cell for the data demanding node, and type an address in the Starting Address cell for the data demanding node. 20-62