Delta ISPSoft — 20.4.4 Node List and Display Area

Chapter 20 Network Configuration and Data Exchange 20.4.4 Node List and Display Area If users click All Node s on the node list, all the nodes will be displayed in the display area, and all the data exchange groups set will be in the data exchange table under the display area. Besides, the devices in which the data demanded will be stored, and the data supply nodes are indicated in device blocks of the nodes in the display area. >2 side of the D block indicate that the data demanded of node 2 will be stored in D500~D509 in node 1. Likewise, >1 side of the D block indicate that the data demanded of node 1 will be stored in D1000~D1019 in node 1.

If the users click a specific node on the node list, the node and the nodes of which the node demands data will be shown in the display area, and the data in the data exchange table under the display will be related to the specific node selected. In the figure below, the dotted frame indicates that node 1 on the node list is selected, and the gray ground indicates that node 2 is a data supply node. Node 2 cannot be selected, and the information in the M block in node 2 indicates the data which will be supplied to node 1. Owing to the fact that node 3 does not supply any data to node 1, node 3 is not displayed in the display area.

The numbers at the left side of the D block in node 1 indicates that the data demanded of node 2 will be stored in D500~D509 in node 1. in the M block in node 2 indicates that the data in M1000~M1129 in node 2 will be supplied to 1. 20-65