Chapter 20 Network Configuration and Data Exchange The users can click to add a new piece of data to the data exchange table. The data includes the data demanding node, the node number assigned to the data demanding node, the data supply node, the node number assigned to the data supply node, and the device types selected. 20.4.5 Start Mode of an Ether Link There are three start modes. Please refer to the table below for more information. Ether Links. *. Please refer to manuals or technical documents for more information about special relays related to The execution of an Ether Link is based on the nodes in a network.
If some of the ports that a node has are connected to a network, users can set the start modes of the ports separately. When the Ether Link constructed is executed, the system automatically distributes reading/writing work to the ports according to the start modes of the ports. If a port is disconnected, the system will pass the work belonging to the port to another port. 20-67 Start mode Description Always Stop During the operation of the PLC, no data exchange is performed. Always Run When the PLC runs, data exchange is performed. SM Flag The performance of data exchange depends on a special relay in the PLC.
After users select SM Flag, they can set the initial state of the related special relay.