Delta ISPSoft — 20.4.11 Monitoring Table and Error Log

Chapter 20 Network Configuration and Data Exchange 20.4.11 Monitoring Table and Error Log After users double-click a data block, the Data Monitor window will appear. The users can view the values in the window. They cannot change the values in the window.  After users click the Radix cell for a device, they can select a method of representing the value in the device on the drop-down list.  The information about the data block which is monitored is displayed.  Users can type a device address in this box. After the users press Enter on the keyboard, they can easily view the device address in the window.

After a node is selected, the error log in the node will be displayed in the Error Log page. If the users select the Ether Link Error Filter checkbox, only the error log related to the Ether Link constructed will be listed. Besides, after the users click Renew , the error log in the node will be retrieved, and the error log retrieved will be displayed in the Error Log page. After the users click Clear , the error log in the Error Log page and the error log in the node will be cleared. the PLC model type is known in the Device Type column and the module position can be found in Rack No. The Error Log page contains error records from hosts and modules.

When an error log is formed by modules, and Slot No. columns. However, when error occurs by CPU, no numbers are shown in Rack No. and Slot No. columns. 20-83