Chapter 20 Network Configuration and Data Exchange 20.5.2 Downloading In NWCONFIG Graphic Workspace, download the routing tables produced to PLCs, the parameters related to the PLC Links constructed, the parameters related to the Ether Links constructed to the nodes. 20.5.2.1 Downloading Parameters Routing table The routing data stored in a PLC is data related to the PLC itself, and therefore the routing tables downloaded to nodes are different. Users have to download the routing tables produced to nodes in the working area. Parameters related to a PLC Link The parameters related to a PLC Link can only be downloaded to the PLC designated as a master station.
If the parameters related to a PLC Link are downloaded to a slave station, the related special relays and the station in a network. If users are not sure whether a device was designated as a master station, and whether related special registers in the slave station will be restored to the default setting. There is only one master the parameters related to a PLC Link was downloaded to the device, they have to download the parameters related to a PLC Link to the device. Parameters related to an Ether Link The parameters related to an Ether Link must be downloaded to the data demanding nodes. However, the data exchange table stored in a PLC is a table related to the PLC itself.
Besides, if the parameters set include a node which does not demand any data, the data in the node will be cleared after the parameter are downloaded to the node, and the start mode of the node will depend on the parameters after the parameters are downloaded to the node. 20.5.2.2 Description of Downloading There are two ways to download. One is Single node , the other is Multiple node . When downloading communication settings, do not use Routing Mode . Single node The users have to select a node in the working area. 20-85