ISPSoft User Manual During E-CAM execution, the CAM may trigger corresponding action in certain specific position and this requires a close/open state setting regarding the assigned position of CAM. When CAM moves to that position, the close/open state change can control the corresponding action and the close/open state is called CAM-tappet. The CAM-tappet can set in any position of CAM and one CAM can set up a maximum of 128 CAM-tappet. When CAM moves across in positive or negative direction, the tappet state can be configured into (close, set, reset, reverse). The tappet state can be obtained through the corresponding command of CAM-tappet in the controller program.
The following chart describes the CAM-tappet state: Note: CAM-tappet state will reset once the next CAM cycle starts. 22-14 Close When CAM passes the corresponding position of tappet, the tappet state does not change. Set When CAM passes the corresponding position of tappet, the tappet state is set to TRUE. Reset When CAM passes the corresponding position of tappet, the tappet state is set to FALSE. Reverse When CAM passes the corresponding position of tappet, the tappet state switch once between TRUE and FALSE. ( If TRUE then change to FALSE, if FALSEthen change to TRUE).