Delta ISPSoft — 22.2.3 Using E-CAM Editor

ISPSoft User Manual Click Setting or to open other setting windows. Explanations are as followed.  Master position: Setting main axis display range in the diagram.  Slave position: Setting slave axis display range in the diagram.  Resolution: Setting the E-CAM table, the total interval curve resolution Click add line segment or and click on the position to add in the diagram and the section below will automatically add the linesegment containing two key points data. When the line segment is added, the function of the CAM curve with line segment added is fixed in Polynomial mode. On the left of the line segment, item ID appears and on the right, Line Start and Line End shows.

To set the interval line segment to into a line n Polynomial mode, right-click the key point in the diagram and then select Become A Line . 22-16