ISPSoft User Manual After the project is created, you can find the PLC label behind the product name in the project management area. You can change the PLC label in HWCONFIG as it is mentioned above. The PLC label is very useful when you have more than one PLC in the project. This label can be seen as the PLC identity. So that you will not change other PLC parameters by mistake. To prevent errors, when you download/upload the program, the system will remind you to check the name of the PLC CPU and the PLC label. 3.1.4.2 System Settings – System Parameter The parameters on System Parameter table are shown in the following window.
You can set appropriate values via a drop-down list or type the values in the box. Clear non-latched area when STOP --> RUN If the state of the CPU module changes from Stop to Run , the states of the non-latched devices and the values in the non-latched devices are cleared. 3-84