Chapter 3 PLC System Configuration & Settings 3.6.2.8 Options - Absolute Encoder The page below is for setting the absolute encoder. The output value for absolute encoder include Gray or Binary. This parameter is set according to the encoder type. The parameter Number of data bits to count turns item sets resolution for multi-turn. A recount will take place if the number of pulses exceeds the valid maximum turn count. The number of turns (N) equals to 2 N . This parameter is set according to the encoder type; the Number of data bits per turn item sets resolution for a single turn. The number of turns (N) equals to 2 N . An encoder turns to create the number of pulses.
This parameter is set according to the encoder type. The item sets data transfer speed. The item determines the minimum transfer speed that counts from the falling edge of the last pulse in clockwise direction. 3-227