Chapter 3 PLC System Configuration & Settings management area, a dialog box will appear before the parameters are downloaded or uploaded. *2. HWCONFIG adopts the communication setting in ISPSoft. Please make sure that ISPSoft is connected to the CPU module normally before the parameters are downloaded/uploaded. Please refer to section 2.4 for more information. 3.8.5 I/O Scan Users can configure modules in the way mentioned above. If users have gotten related hardware, they can install the hardware, click I/O Scan in HWCONFIG, and scan the actual hardware configuration through communication. The time of configuring the modules will be saved.
Users have to make sure that ISPSoft has connected to the CPU module normally before they carry out the operation. Please refer to section 2.4 for more information about communication setting. Users can click I/O Scan on the Option menu, or which will be scanned include the module models, the hardware configuration, and the firmware versions of the on the toolbar to carry out the operation. The contents modules, but do not include the parameters in the modules and the parameters in the CPU module. After I/O Scan is clicked, the original hardware configuration and the parameter setting will be cleared. However, the parameters in the CPU module will not be affected.
After the scan is complete, the actual hardware configuration will be displayed in the system configuration area, the system will assign input/output devices to the modules, the parameters in the modules are assigned the default values. 3-245