ISPSoft User Manual Please make sure that the hardware configuration, the parameter setting, and the task management are completed. If the hardware configuration, the parameter setting, and the task management are not completed, the users have to refer to chapter 4~chapter 6, and complete the hardware configuration, the parameter setting, and the task management. After the hardware configuration, the parameter setting, and the task management are completed, the users can compile the program again, and download the parameters and the program to the CPU module. Before the program is downloaded to the CPU module, the users have to select the Initial Value checkbox in the Transfer Setup window.
Once the Initial Value checkbox in the Transfer Setup window is selected, the initial value of CNT_DT in PARTS_CNT will be written into the CPU module. When the program is downloaded, the users can click and on the toolbar. Please follow the steps below, and test the characteristics of the function blocks. Open the window for RUN_STOP , and force START_BT ON. RUNNING is ON. The equipment begins to run. 7-44