Chapter 2 Starting and Setting ISPSoft The following chart shows analog input and output registers area. Each column requires 32-bit floating- point format and corresponds to every channel of the actual module; for D8 and D10 (see below) corresponds to analog output channel - D device, the output are for viewing only; while D0, D2, D4 and D6 corresponds to analog input channel - D device. Users can click to open the setup window (see below) for analog input value. When setting is complete, the column (channel) will continue to send data to COMMGR based on the signal mode setup. While ISPSoft can conduct related tests when capturing simulator signals through COMMGR.
2-55 Signal Type Description Constant A constant signal with fixed value. Random To assign the maximum and minimum value of random signal. Sine Wave To assign the maximum or minimum value and signal cycle of sine wave. Square Wave To assign the maximum or minimum value, ON and OFF times of cyclic square wave. Triangle Wave To assign the maximum or minimum value and signal cycle of triangle wave.