AMD NVMe/SATA RAID Quick Start Guide for Windows Operating Systems 56268 Rev. 1.05 November 2021 Chapter 3 Pre-Installation Steps 3.1 Enable RAID for x570/590 AMD Socket AM4/SP3- Series Compatible Processors Note: The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS based off the AMI BIOS . The steps for other BIOS Vendors are different. Complete the following pre-installation steps: 1. Power-on the system. 2. Press ESC to enter the System BIOS setup page. 3. In the BIOS setup: a. Select the Advanced tab. b. Select CSM Configuration , then press Enter. c. Set CSM Support to Enabled , then press Enter. d. Set Boot option filter to UEFI only, then press Enter. e.
Set Storage to UEFI , then press Enter. 4. In the BIOS setup: a. Select the Advanced tab. b. Select AMD CBS , then press Enter. c. Select FCH Common Options , then press Enter. d. Select SATA Configuration Options , then press Enter. e. Set SATA Enable to Enabled , then press Enter. f. Set SATA Mode to RAID , then press Enter. 5. In the BIOS setup: a. Select the Advanced tab. b. Select AMD CBS , then press Enter. c. Select X570/590 Chipset Common Options , then press Enter. d. Select X570/590 Chipset SATA Configuration Options , then press Enter. e. Set X570/590 Chipset SATA0 Enable to Enabled , then press Enter. f. Set X570/590 Chipset SATA1 Enable to Enabled , then press Enter. g.
Set X570/590 Chipset SATA Mode to RAID , then press Enter. 6. In the BIOS setup: a. Select the Advanced tab. b. Select AMD PBS tab, then press Enter. c. Set the NVMe RAID Mode to Enabled, then press Enter. 7. Save ( F4 ) the settings and restart the system. 10 Pre-Installation Steps Chapter 3