AMD NVMe/SATA RAID Quick Start Guide for Windows Operating Systems 56268 Rev. 1.05 November 2021 3.5 Enable RAID for FP6 Processors Note: Raid configuration support is restricted to Raid0 level only. The steps to configure a system to RAID mentioned here are specific to AMD NDA BIOS based off the Insyde BIOS . 1. Power-on the system. 2. Press ESC to enter the System BIOS setup page. 3. In the BIOS setup: a. Select AMD PBS tab, then press Enter. b. Set the NVMe RAID Mode to Enabled, then press Enter. 4. Save ( F10 ) the settings and restart the system. 14 Pre-Installation Steps Chapter 3