AMD NVMe/SATA RAID Quick Start Guide for Windows Operating Systems 56268 Rev. 1.05 November 2021 and RAID level selected. If you want a smaller size Array size, enter the desired value. c. Press Enter when the desired size is reached. 7. Use the arrow keys to select Cache Tag Size. b. The Array size will default to the Maximum size allowed by the number of physical disks a. Any Array with only HDD/SSD has the default CTS of 64 k. b. Any Array with only NVMe or NVMe with HDD/SSD has the default CTS of 256 k. 8. Use the arrow keys to select Read Cache Policy, then press Enter. a. Select the desired Read Cache Policy , then press Enter. 9.
Use the arrow keys to select Write Cache Policy, then press Enter. a. Select the desired Write Cache Policy , then press Enter. 10. Use the arrow keys to select Create Array , then press Enter. 11. After completion of the array creation, select Save and reboot the BIOS. 4.2 RAIDXpert2 Configuration Utility (HII Mode) for the AMD Ryzen™ SP3-Series Processor 4.2.1 Use Configuration Utility (HII) to Create a Bootable Virtual Disk Note: The steps to configure arrays in RAID mode mentioned here are specific to AMD NDA BIOS and are based off AMI BIOS . 1. Power-on the system. a. Press ESC or DEL to get into the Platform BIOS. b. Select the Advanced tab. c.
Select RAIDXpert2 Configuration Utility , then press Enter. 2. At the RAIDXpert2 Configuration Utility’s Main Menu, use the arrow keys to select Array Management , then press Enter . 3. Use the arrow keys to select Create Array , then press Enter. 4. Select RAID Level , then press Enter . a. From the Select RAID Level drop-down menu, use the arrow keys to select the desired RAID level, then press Enter. 5. Select the disks with which to create the array: a. Use the arrow keys to select Select Physical Disks , then press Enter. b. To select individual disks, highlight a disk with the arrow keys and press the Space Bar or Enter . Any number of disks may be selected using this method. c.
To select all disks, use the arrow keys to select Check All , then press Enter. d. Use the arrow keys to select Apply Changes , then press Enter. 6. Select an array size by doing the following: 16 Create the Bootable Virtual Disk Chapter 4