Adjusting the 2000-sheet Printer Input Tray This procedure applies to the 2000-sheet Input Tray. To adjust Trays 2 and 3 (the standard paper trays in the printer) and the 2 x 500-sheet Input Tray (Trays 4 and 5) see page 169. In some cases, the registration from the 2000-sheet Input Tray causes print to start too close to the edge of the paper. This situation is not a typical occurrence. In most cases the 2000-sheet Input Tray offset is fine. Although this may or may not be within specification, it is unacceptable to some users. Perform the following adjustment procedure to correct the situation. 1 With the 2000-sheet Input Tray stand-alone, remove left, right and rear covers from the tray.
2 Remove the vertical transfer unit. 3 Open the 2000-sheet Input Tray paper tray. 4 Loosen both screws that support the paper tray locking bracket on the right side of the 2000-sheet Input Tray (see figure 4-5). Figure 4-5 Tray 4 Position Adjustment 5 Locate the bracket hole and pin at the middle (right side) (see figure 4-5). 6 Slide the bracket so that the locating pin is positioned at the middle of the bracket hole. 172 Chapter 4 Maintenance and Adjustments C4265-90907