Printer components of copy module power up process M The printer performs startup procedures. Note The Scanner Service Agent is part of the copy module firmware that loads from the printer's hard disk drive into the printer's RAM on power up. When this happens, you see Loading Program 1 or Loading Program 2 on the front panel of the printer. This program runs continuously, instructing the printer how to handle requests and information from the copy module. M The printer loads the Scanner Service Agent from the printer hard disk drive. Loading Program 1 or Loading Program 2 displays on the printer’s Front Panel. Additional programs may be added later for support of additional functionality.
Note The units must be power cycled once the copy module firmware is installed. Notes About the MFP Printer Product ID Versions 5.32 and older firmware for the copy module stored a product ID in NVRAM and also on the hard disk. With an older version of firmware and no product ID in NVRAM or on the hard disk, the copy module will hang on icon 2 of the copy module control panel when you turn it on. If this problem occurs, download the latest version of copy module firmware from http://www.hp.com. Version 5.40 or later firmware will work with a LaserJet 8000, 8100, 8150, Moper 240 and Mopier 320 and does not require a product ID.
The only way to remove the product ID is to perform an NVRAM initialization. CAUTION There are different methods of downloading firmware for the copy module. There is one method for downloading when using digital sending and one method for downloading when using the copy functionality only. See “Upgrade HP Digital Copier Firmware” on page 150 C4265-90907 Copy Module Power Up Process 245