Tray 2 and 3 Assemblies Note The paper trays are mechanically aligned to the printer chassis at the factory. If you are replacing Tray 2 or Tray 3 with a tray other than the original factory installed unit, you may have to adjust the new tray. For details, see “Adjusting Printer Input Trays” on page 169. 1 Open the tray, and pull it out to the stop. 2 Press the colored tab at the right side of the tray, and continue to pull the tray slightly upwards and out of the chassis. To Reinstall: 1 Align the left rear corner of the tray and the locating track at the lower rear center of the tray with their respective guides, and insert the tray no more than two inches into the chassis.
2 Carefully lift up on the outer end of the tray while pulling the tray stop mechanism, located at the right rear of the tray opening, out and over the tray roller and guide assembly. 3 Carefully slide the tray into the printer until it latches into place. C4265-90907 Printer Assembly Removal and Replacement 339