Vertical Transfer Unit (VTU) Figure 6-78 2000-sheet Input Tray Vertical Transfer Unit (VTU) 1 Open the Vertical Transfer Unit (VTU) on the 2000-sheet Input Tray. 2 Rotate the 2 plastic cams on the VTU hinges toward the 2000-sheet Input Tray to the secure position (Figure 6-78, callout 1). WARNING! Do not release the plastic cams from the secure position while the VTU is off. The springs on the cams are very strong and may cause injury. 3 Locate the 2 cables that run from the VTU to the chassis at the right side’s upper-back corner (Figure 6-78, callout 2) and disconnect the 2 cables from the chassis. 4 Remove the 2 screws that secure the VTU to the chassis:
1 screw near each end of the VTU (Figure 6-78, callout 3). 5 Lift the VTU straight up to clear the metal locating tabs on the chassis. Note Reassembly notes are on the next page. 366 Chapter 6 Removal and Replacement C4265-90907