Figure 6-158 8-bin Mailbox Flipper Assembly (3 of 3) 7 Hold down the Jam Access Door, and pull out the Flipper Assembly (Figure 6-158, callout 5). To Reinstall: 1 Hold down the Jam Access Door to reconnect the ground wire to the Flipper Motor (Figure 6-157, callout 2). 2 Route the Flipper Assembly’s 3 cables through the back side of the 8-bin Mailbox frame and reconnect the 3 cables to the connectors (Figure 6-156, callout 3). CAUTION Do not over-tighten the screws that secure the Flipper Assembly to the 8-bin Mailbox frame. The nuts in the Flipper Assembly could rotate in their slots. 452 Chapter 6 Removal and Replacement C4265-90907