HP — Carrier Unit

Figure 6-253 Unplugging the Ribbon Cable 4 To release the Ribbon Cable, use your fingernail to gently pull up each end of the connector (callout 1). Unplug the ribbon cable. Note the orientation of the contacts on the cable so the cable is not twisted. CAUTION During reassembly, when you insert the Carrier Shaft, be careful not to dislocate the Felt Pad in the Carrier Frame. See page 562. 5 Remove the Carrier Unit. Note The replacement Carrier Unit includes a Lamp, Dust Cover, and pre- lubricated Felt Pad. A ribbon cable is not included.

CAUTION If the brass bushing comes off the rail, be sure to replace it so that the rail fits into the bushing’s groove, and the bushing does not sit on top of the rail. If the bushing sits on top of the rail, it can block the Carrier Unit. C4265-90907 Copy Module Flatbed Assemblies 561