HP — Front Panel Ribbon Cable

Figure 6-261 Unplugging the Ribbon Cable 2 Remove the Front Panel Cable Clamp and Front Panel Frame Ground Plate (figure 6-210 on page 516). 3 To release the Ribbon Cable, use your fingernail to gently pull up each end of the connector (callout 1). Unplug the ribbon cable. Note the orientation of the contacts on the cable so the cable is not twisted. To replace CAUTION You must remove the Front Panel Cable Clamp and Front Panel Frame Ground Plate in order to replace the cable. The cable will be crushed if you place it over the top of the clear cover. 1 Remove the Front Panel Cable Clamp and Front Panel Frame Ground Plate.

2 Replace the Ribbon Cable and the Front Panel Cable Clamp and Front Panel Frame Ground Plate. 3 Make sure the Front Panel Cable Clamp lies as flat as possible, allowing the Carrier Unit to pass over without touching the clear part. C4265-90907 Copy Module Flatbed Assemblies 569