L-4733A/L-4733AW Operation Guide Overview of the Product Basic specifications 27 Press Main Unit and Touch Panel External dimensions Length: 5100 mm Width: 1910 mm (With Rewinder) Length: 3950 mm Width: 1910 mm (Without Rewinder) U “External dimensions and necessary space” on page 34 Necessary space Work space including the press (With Rewinder): Length: 6.7 m Width: 3.1 m Floor space required for installing the press: 9.8 m2 (With Rewinder) 7.6 m2 (Without Rewinder) U “External dimensions and necessary space” on page 34 Mass Press total mass: Approx.
1,550 kg (not including the control computer, substrate, ink cartridges, and Rewinder.) Rated input AC (three-phase three-wire) 200 V Input voltage range fluctuation ±10% (180 V minimum and 220 V maximum) Rated frequency range 50/60 Hz ±1% Rated current 30 A (maximum current 50 A) Rated power 6000 W Rated short circuit current 2.5 kA Printing method On-demand ink jet Printing resolution 720×360 dpi, 720×540 dpi, 720×720 dpi, 720×1080 dpi, 720×1440 dpi, 1440×720 dpi Ink Pigment ink cartridge (Cyan, Magenta, Yellow, Black, Orange, Uncoated Black, and Green) 700 ml each Pigment ink cartridge (White) 600 ml Pigment ink cartridge (Over Print Liquid, Moisture Liquid, Storage Liquid) 700 ml each (a 350 ml Moisture Liquid can also be used) Maintenance tank Holds 9.3 liters of drainage Floor load capacity 400 kg/m2 Do not place the press on materials such as carpet or urethane foam (or any type of resin).
Because the point loads use a level adjuster, if you are concerned about damaging the floor use a load distribution board.