L-6534VW Operation Guide Basic Operations L Press Move Sensor . The eye mark sensor moves to the position entered in step 11. M Press the Feed / Slow Feed switch or the Slow Rev. Feed switch on the press to feed the substrate, and align the eye mark sensor light over an eye mark on the substrate. c Important: The skew correction function is disabled during the reverse feed of the substrate. Pressing the Rev.Feed switch or setting Feeding Amount to a negative value to perform reverse feed may cause the substrate to skew and be misaligned. Aligning the eye mark sensor light over an eye mark on the substrate under these conditions may disable detection of eye marks during printing.
Adjust to the eye mark at the point where printing starts. See the following illustrations to place the sensor light on the eye mark. When the check box for Auto Center Align is selected Good example Bad example When the check box for Auto Center Align is cleared Good example Bad example 130