L-6534VW Operation Guide Basic Operations Note: Even if you change the number of copies, those that were processed before the setting was changed are still printed. Also, when the print complete process is performed before settings are reflected, the changed settings are disabled. To guarantee the changes are reflected, press the Pause switch to stop printing first, and then change the number. After making changes, press the Start switch to restart printing. H Wait until printing is complete. ❏ When Pause (After Print) is set to Apply in the preset, the Paused screen is displayed. After checking, press the Start switch to finish the print job.
❏ When Result Check is set to Apply in the preset, printing stops with the Operation Status screen showing job information for the current job. Check the information such as the amount of substrate used, and then complete the printing process. c Important: If a roll end error occurs while printing a job, and when replacing with the same type of substrate from the Change Substrate screen, the print position may shift. Use the following procedure to replace the substrate. U “The print position shifts when replacing with the same type of substrate during a print job” on page 403 Note: ❏ When printing is complete, the press starts printing the next job.
If you want to change to standby status, move the press switch from Ready to Standby . ❏ When printing under the following conditions, the substrate passes the stop point when printing is complete, is fed backward, and then stops at the correct stop position. ❏ Using the additional UV lamp curing unit ❏ When the tension value for unwinding or rewinding is 10 N or less This completes this section. 139