L-6534VW Operation Guide Various Print Settings E Check that the press switch is set to the Standby position. F Perform printing from the print application software, and then check that the print data was received on the touch panel. G Select the print job from the Job Management menu, and then press Print Settings . H Set the following, and then press OK . I Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing. Print the first copy, and then the press automatically adjusts the sensor sensitivity. J If the first copy pauses on the unwinder side workbench, press Print to Fine-tune .
Print the second copy, and then pause on the unwinder side workbench. K Check the print results and measure the eye mark pitch (a) from the right edge of the eye mark for the first copy to the right edge of the eye mark for the second copy using a ruler with a 0.1 mm scale. L Calculate the adjustment value from the measured eye mark pitch (a) and the page length of the print data. The following shows the calculation method. Adjustment value = Value of measured eye mark pitch (a) - Page length of the print data M Enter the calculated adjustment value in Reverse Feeding Position Adjustment . 177 Item Set value Copies 1 Perform Eye Mark Verification Printing Select