L-6534VW Operation Guide Various Print Settings Procedure for Surface Printing A Set additional printing for surface printing in a preset suitable to the type of substrate loaded, and set it as the default preset. U “Necessary Settings for Surface Printing” on page 187 U “Creating and Editing Preset for Printing” on page 91 B Set surface printing in the preset for reverse feeding, and set it as the default preset. U “Creating and Editing Preset for Reverse Feeding” on page 95 C Check that the press switch is set to the Standby position. D Return to the Operation Status screen to perform printing from the print software, and check that the surface print data has been received.
E Select the print job from the Job Management menu, and then press Print Settings . F Set the following, and then press OK . G Replace the substrate. Replace the unwinder side substrate. Load the substrate so that the unwinder side feeds clockwise. Select Clockwise for Unwinding Direction U 188 Item Set value Copies 1 Perform Eye Mark Verification Printing Select inder Side Substrate” on page 99