EPSON — Paper width sensor/Eye mark sensor

L-6534VW Operation Guide Maintenance B Clean the paper width sensor (a). The paper width sensor (a) is the section on the unwinder side where the LED emits light. Clean the sensor at the top and the reflectors at the bottom. Wipe off any paper powder, dust, and so on with the dry polyester/nylon knit woven fabric. a. Paper width sensor b. Eye mark sensor c Important: When cleaning the paper width sensor, make sure you use a dry cloth, and wipe it gently without using too much force. C Clean the eye mark sensor (b). The eye mark sensor (b) is the part that emits LED light on the drum side. Clean the sensors at the top and the bottom.

Dampen the polyester/nylon knit woven fabric with the alcohol for cleaning the rollers, and then wipe off any paper powder, dust, glue, and so on. D Check that there are no tools or jigs left inside the press. c Important: Do not leave any foreign substances inside the press. Print quality may decline, or the head could break down. You need to replace the head if it breaks down. E Remove slack from the substrate. F Return the three nip levers, and then set nip rollers A and B, and the foreign substance detection roller. If you are going to clean the foreign substance detection roller next, go to the appropriate item without returning the nip levers.

U “Foreign substance detection roller” on page 285 G Close the top front cover on the press. 284