EPSON — Replacing the additional UV curing lamp

L-6534VW Operation Guide Maintenance Replacing the additional UV curing lamp Set the breaker to OFF before beginning work, or after ending work. If you are replacing parts immediately after using the press, set the breaker to OFF and then wait for at least 10 minutes before starting operations. Caution: Check that the lamp has cooled sufficiently before replacing the lamp in the additional UV lamp curing unit. Burns could occur if you touch them while in operation or immediately after operation. If a burn does occur, run it under cold water immediately and consult your doctor. Note:

❏ The UV light energy decreases for the additional UV curing lamp according to the lighting hours or the number of times it is used. ❏ You should aim to replace it after approximately 1,000 hours of lighting. ❏ To check whether the additional UV curing lamp needs to be replaced, print a test pattern. ❏ Make sure you purchase the following additional UV curing lamp. Mercury lamp for Cool Arc350 (part no. 760004861) A Check that the breaker is set to OFF . B Open the cover at the bottom of the additional UV lamp curing unit, and then open the additional UV lamp curing unit lamp cover. 328