EPSON — Pinnings/Curing unit 1/Curing unit 2

L-6534VW Operation Guide Maintenance Note: There are three points inside the mist vacuum where the mist vacuum cleaning jig may get stuck as you drag it along. Make sure you allow the cleaning jig to follow the internal shape of the mist vacuum. Wipe off any ink that sticks to the mist vacuum cleaning jig with a polyester/nylon knit woven fabric dampened with the liquid for ink cleaning. Repeat mist vacuum cleaning until there is no ink stuck to the cleaning jig. C Wipe off any ink deposits from the mist vacuum opening with a cleaning stick dampened with the cleaning liquid for ink cleaning. D Close the top rear cover, the left rear cover, and the right rear cover on the press.

When cleaning the pinnings or the curing units next, continue to the next item without closing the top rear cover, the left rear cover, or the right rear cover. U “Pinnings/Curing unit 1/Curing unit 2” on page 340 E Add a check mark to the item you have inspected, and then go to the next item for inspection. When you have finished the inspection, press Finished . This completes this section. Pinnings/Curing unit 1/Curing unit 2 If ink deposits accumulate on the light emitting glass for the curing unit or the pinning, it could have an adverse effect on the printing results. If you are performing this procedure after cleaning the mist vacuums, go to step 2. 340