EPSON — Removing the Substrate

L-6534VW Operation Guide Troubleshooting When Re-loading Substrate If you need to reload after removing the loaded substrate, use the following procedure. Caution: ❏ When loading or removing roll substrate, be sure to secure appropriate personnel and appropriate transport equipment such as a lifter according to local laws on health and safety. You can install the roll substrate up to 100 kg (the diameter is up to ш600 mm). Transporting, loading, or removing the roll substrate without following the instructions is extremely dangerous and could cause injuries such as trapping a hand or finger or dropping it on your foot.

❏ Be sure to adopt a sensible lifting posture whenever you lift the roll substrate. If you do not use the correct posture, an injury could occur. Removing the Substrate A While printing, press the Pause switch to pause printing, and then cancel the job. U “Canceling a Print Job” on page 142 B Open the top front cover on the press. 368 Contents Reference Cut the substrate on the unwinder side workbench and remove the unwinder side substrate. On the rewinder side, manually wind the substrate, and then remove it from the rewinder axis.

U “Removing the Substrate” on page 368 Install the substrate to the unwinder axis, load it along the path channel, and affix it to the paper core of the rewinder axis. U “Loading the Substrate from the Beginning” on page 371