L-6534VW Operation Guide Starting and Ending the Press H Ink temperature adjustment starts. It takes approximately 15 minutes until the following screen is displayed. You can also replace the substrate at this time. U “Replacing the Substrate” on page 98 Note: In some circumstances, such as when the environmental temperature is low, it may take a long time to adjust the ink temperature. I Perform the startup inspection. Press Switch Mode , open the covers necessary to perform the inspection, and then perform the displayed inspection items. Add a check mark to the item you have inspected, and then go to the next item for inspection. When you have finished the inspection, press Finished .
See the following for more details on the operation procedures for each inspection item. U “Maintenance” on page 238 After the Startup Inspection, print a chart to check the print quality if necessary. U “Cleaning Nozzles” on page 152 Note: When you restart the press, the inspection and cleaning screen is displayed. You can skip this screen by pressing Cancel Periodic Maint. 79