L-6534VW Operation Guide Basic Operations Creating Preset for Reverse Feeding When printing stops temporarily for head cleaning, drum temperature adjustment, and so on, a margin of approximately 16 m is generated (at a print speed of 30 m/min) between pages when printing resumes. By using the reverse feeding function, you can continue printing from the last page before printing was stopped by reverse feeding in advance. Also, by using eye marks when reverse feeding substrate, you can increase the accuracy of the print alignment. When using the reverse feeding function, set the preset for reverse feeding on the Preset Management - For Reverse Feeding tab.
See the following for details on each item. U “Preset for reverse feeding editing Screen” on page 56 If you use eye marks to align the substrate when reverse feeding, place the eye mark for reverse feeding on the print data. See the following. U “Creating Print Data” on page 87 Note: Substrate is fed automatically in the following situations to guarantee the necessary reverse feeding amount. ❏ When head cleaning starts just after printing starts ❏ When Print to Verify Eye Mark is selected ❏ When the actual printing in the job is less than 18 m (at a print speed of 30 m/min) The print length of the job varies depending on the print speed selected in Preset for Printing.
U “Print Length of a Job When the Reverse Feeding Amount Is Not Secured” on page 72 ❏ When using the Pause switch to stop just after printing starts, and restarting printing with the Start switch At this time, a margin of up to 10 m occurs between pages. 94 Set value Explanation Reverse Feeding: Do Not Apply Does not perform reverse feed of substrate after pausing and so on. After printing resumes, a margin of approximately 16 m is generated (at a print speed of 30 m/min) between pages. The margin varies depending on the print speed selected in Preset for Printing. U “Margins Between Pages When Resuming Printing” on page 71 Reverse Feeding: Apply Eye Mark for Reverse Feeding:
Do Not Use Performs reverse feed of substrate after pausing and so on, but the eye marks are not adjusted. A margin of up to 200 mm is left and printing continues. Reverse Feeding: Apply Eye Mark for Reverse Feeding: Use Performs reverse feed of substrate after pausing and so on, and the eye marks are adjusted. Set this when you need to align the substrate precisely. This setting improves issues that occur when pausing and resuming printing causes gaps in the print results that require readjustment of the die cutting position during post-processing.