Last Modified: 6-7-2017 6.8:8.0.40 Doc ID: RM0000013BU004X agn Model Year Start: 2006 Model: Land Cruiser Prod Date Range: [05/2005 - ] Title: A750F AUTOMATIC TRANSMISSION: AUTOMATIC TRANSMISSION FLUID: ADJUSTMENT; 2006 MY Land Cruiser [05/2005 - ] ADJUSTMENT 1. BEFORE REFILL TRANSMISSION This transmission requires Toyota Genuine ATF WS transmission fluid. After servicing the transmission, you must refill the transmission with the correct amount of fluid. Maintain the vehicle in a horizontal position while adjusting the fluid level. If the transmission pan, drain plug, valve body or torque converter is replaced, proceed to the "fill transmission pan" procedures.
If the transmission hose or output shaft oil seal is replaced, remove the refill plug and proceed to the "fill transmission" procedures. If the entire transmission is replaced, proceed to the "perform fluid circulation" procedures. HINT: New transmissions are already filled with transmission fluid. 2. FILL TRANSMISSION PAN (a) Remove the refill plug and overflow plug. (b) Fill the transmission through the refill hole until fluid begins to trickle out from the overflow tube. (c) Reinstall the overflow plug. 3. FILL TRANSMISSION (a) Fill the transmission with the amount of fluid listed in the table below. (b) Reinstall the refill plug to prevent the fluid from splashing. Standard capacity:
REPAIR CAPACITY Transmission pan and drain plug removal 1.7 liters (1.8 US qts, 1.5 Imp. qts) Transmission valve body removal 4.3 liters (4.54 US qts, 3.78 Imp. qts) Torque converter removal 5.4 liters (5.71 US qts, 4.75 Imp. qts) HINT: If the amount of fluid listed in the table cannot be added, perform the next step. (c) When the amount of fluid listed in table cannot be added: (1) Install the refill plug. (2) Allow the engine to idle with the air conditioning OFF. (3) Move the shift lever through the entire gear range to circulate fluid. (4) Wait for 30 seconds with the engine idling. (5) Stop the engine. (6) Remove the refill plug and add fluid. (7) Reinstall the refill plug. 4.
PERFORM FLUID CIRCULATION (a) Allow the engine to idle with the air conditioning OFF. (b) Move the shift lever through the entire gear range to circulate fluid. (c) Allow the engine to idle until the fluid temperature reaches 36°C (97°F). Proceed to the next stop to check fluid temperature. HINT: The fluid temperature should be less than 30°C (86°F) before starting the engine. cardi