(419°F) TESTER DISPLAY MEASUREMENT ATF temperature ITEM/RANGE sensor No. 2 NORMAL CONDITION DIAGNOSTIC NOTE A/T OIL TEMP2 value/ Min.: -40°C (- 40°F) Max.: 215°C (419°F) After stall test: Approximately 80°C (176°F) Equal to ambient temperature while engine is cold If value is -40°C (-40°F) or 215°C (419°F), ATF temperature sensor No. 2 circuit is opened or short circuited LOCK UP Lock up/ ON or OFF Lock-up is Operating: ON Not operating: OFF - LOCK UP SOL Lock-up solenoid status/ ON or OFF Lock-up solenoid is Operating: ON Not operating: OFF - SOLENOID(SLU) Shift solenoid SLU status/ ON or OFF Shift solenoid SLU is Operating: ON Not operating:
OFF - SOLENOID(SLT) Shift solenoid SLT status/ ON or OFF Accelerator pedal is depressed: OFF Accelerator pedal is released: ON - 2. PERFORM ACTIVE TEST HINT: Performing the intelligent tester's ACTIVE TEST allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST. (a) Warm up the engine. (b) Turn the ignition switch OFF. (c) Connect the intelligent tester to the CAN VIM. Then connect the CAN VIM to the DLC3. (d) Turn the ignition switch ON. (e) Turn the tester ON. (f) Enter the following menus:
DIAGNOSIS / OBD/MOBD / ECT / ACTIVE TEST. (g) Perform the ACTIVE TEST. TESTER DISPLAY TEST PART CONTROL RANGE DIAGNOSTIC NOTE LINE PRESS UP* Operate the shift solenoid SLT and raise line pressure ON or OFF HINT: OFF: Line pressure up (when Active Test "LINE PRESS UP" is performed, ECM commands SLT solenoid to turn OFF) ON: No action (normal operation) [Vehicle Condition] Vehicle stopped Engine: idling LOCK UP Control shift solenoid SLU to set automatic transmission to lock-up condition ON or OFF Possible to check shift solenoid valve SLU operation [Vehicle Condition] Throttle valve opening angle: Less than 35% Vehicle speed:
60 km/h (36 mph) or more SHIFT Operate shift solenoid valve and set each shift position by yourself Press "→" button: Shift up Press "←" button: Shift down Possible to check operation of shift solenoid valves [Vehicle Condition] 50 km/h (30 mph) or less HINT: *: "LINE PRESS UP" in the ACTIVE TEST is performed to check the line pressure changes by connecting SST to the automatic transmission, which is used in the HYDRAULIC TEST as well. Please note that the pressure values in the ACTIVE TEST and HYDRAULIC TEST are different.