(c) Insert a screwdriver between the door and the door trim to pry the trim. NOTICE: Be careful not to damage the door and the door trim. HINT: Tape the screwdriver tip before use. (d) Pull the trim upward to remove it. gn 8. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY (a) Remove the screw and inside handle. (b) Disconnect the 2 control cables from the inside handle as shown in the illustration. 9. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY (a) Disconnect the connector, and then remove the bolt and the tweeter speaker. 10. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY (a) Disconnect the connector, and then remove the 3 bolts and outside rear view mirror. 11.
REMOVE FRONT DOOR SERVICE HOLE COVER (a) Remove the clamps and wire harness. (b) Remove the service hole cover. NOTICE: Do not tear the cover. HINT: At the time of reassembly, pull out the 2 control cables and wire harness through the service hole cover. 12. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY (a) Remove the screw. (b) Using a scraper, remove the door belt moulding. HINT: Tape the screwdriver tip before use. 13. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY (a) Open the door glass until the bolts appear in the service hole. (b) Remove the 2 bolts and the door glass. Torque: 8.0 N·m {82 kgf·cm, 71in·lbf} NOTICE: Do not damage the door glass. HINT: Pull the glass upward to remove it. 14.
REMOVE FRONT NO. 1 DOOR SPEAKER ASSEMBLY (a) Remove the 3 screws and speaker, and then disconnect the connector. 15. REMOVE FRONT DOOR GLASS RUN 16. REMOVE FRONT DOOR FRAME SUB-ASSEMBLY REAR LOWER (a) Remove the bolt and frame sub-assembly rear lower. 17. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY cardia