4. Motion Control Instruction 4.6.35. MOVB Explanation of the instruction: When EN is on, the zone data with S1 as the starting register data is sent to the zone with D as the starting register and the data length is specified by S2. When the data length S2 is larger than maximum 64, it is counted as 64. And the part above 64 is invalid. MOVB is used for sending multiple source register values to the corresponding multiple target registers. Explanation of input and output parameter of the instruction:
Program example 4-138 DVP-MC operating manual API Move multiple register data to the target registers Controller MOVB 162 10MC11T Parameter Data Available Explanation name type device EN “MOVB” is executed as “EN” turns on. BOOL M,I,Q, constant S1 The starting register of the source zone where the data comes from. INT D S2 The length of the transmitted zone, the max value for S2 is 64. UINT Constant,D D The starting register of the target zone INT D