4. Motion Control Instruction Cutting position Knife 2 O Cutting position The end curve It is the rotary cut curve when the rotary cut function is broken away. Rotarycut axis Sync area Adjustment area End point Sync area Feed axis Start of sync area End of sync area Cutting length After the instruction “APF_RotaryCut_Out” is started up, the system will use the curve to make the rotary cut axis break away from the rotary cut state. Eventually, the knife stops at the end position as shown in the figure above. The end position is based on the rotary axis. For the single knife, the end position is the entry position and it is also right above the rotary cut roller.
4-164 DVP-MC operating manual Knife 1 horizontal line