2. System Function Figure 2.3.2 position of the G codes to be executed. Also, CNC editor can provide the function of one single -step execution of the current G-code document to ensure the correctness of debugging of G codes. CNC editor provides the function of debugging of the current G codes so that user only need preset the target 2.3.5.1. CNC Program Downloading and Debugging When users use the motion control program to call CNC program, the value: 0 of parameter NcTableID of DMC_NC indicates to download CNC program in dynamic way. CANopen Builder provides the following tools for downloading and debugging :
Start to download dynamically CNC program which will be executed after controller receives the first program. : Make the current CNC program run and stop at the place selected by cursor, which is convenient for user to debug the current CNC program. : Single -step execution of CNC program; execute one row every time and when the current row of program is executed, it will be displayed in yellow. 2.3.5.2. The Protocol for Dynamic Download of CNC Program DVP10MC11T supports the open protocol for download of CNC program. User could autonomously develop the process software in PC end to produce G codes and dynamically download the codes to DVP10MC11T for execution. DVP-MC operating manual 2-25