lexus — Cruise control

175 SYSTEM OUTLINE The cruise control system is a constant vehicle speed controller which controls the opening angle of the engine throttle valve by the SW, and allows driving at a constant speed without depressing the accelerator pedal. SET OPERATION When the CRUISE SW is turned on, the systems starts preparations for cruise control and turns on the indicator light in the combination meter. SET SPEED CONTROL When the SET/COAST SW is operated with the CRUISE SW turned on during driving, the speed is controlled at a constant speed.

COAST CONTROL When the SET/COAST SW is kept turned on during cruise control driving, the engine control module controls the throttle valve to decelerate the vehicle speed. Every time the SET/COAST SW is turned on instantaneously, the vehicle speed is decelerated approx. 1.5 km/h. ACCEL CONTROL When the RES/ACC SW is kept turned on during cruise control driving, the engine control module controls the throttle valve to accelerate the vehicle speed. Every time the SET/COAST SW is turned on instantaneously, the vehicle speed is accelerated approx. 1.5 km/h. RESUME CONTROL If the vehicle speed is within the low speed limit (Approx.

40 km/h, 25 mph) when canceling the cruise control, operation of the RES/ACC SW accelerates the vehicle speed and resumes the level before canceling the cruise control. MANUAL CANCEL MECHANISM If any of the following signals are input during cruise control driving, the cruise control is canceled. ∗ The stop light SW is on ∗ The CANCEL SW is turned on ∗ The CRUISE SW is turned off AUTO CANCEL FUNCTION If any of the following conditions are detected, the cruise control is canceled:

∗ Failure in the stop light SW wiring ∗ Abnormality in the vehicle speed signal ∗ Malfunction in the electronically controlled throttle parts OVERDRIVE FUNCTION The overdrive may be canceled if the vehicle travels on a upward slope during cruise control driving. After the overdrive is canceled, if the vehicle speed exceeds the overdrive return speed (Set speed ( 2 km/h, 1.2 mph) ) and it is determined that the slope has finished, and the vehicle returns to overdrive mode again. SYSTEM OUTLINE SERVICE HINTS E7 (B), E9 (D), E10 (E) ENGINE CONTROL MODULE IGSW–E1 : 9.0–14.0 volts with ignition SW at ON or ST position BATT–E1 : Always 9.0–14.0 volts STP–E1 :

7.5–14 volts with brake pedal is depressed : Below 1.5 volts with brake pedal is released C20 CRUISE CONTROL SW [COMB. SW] 4–3 : Approx. 418 Ω with CANCEL SW on : Approx. 68 Ω with RES/ACC SW on : Approx. 198 Ω with SET/COAST SW on SERVICE HINTS