lexus — Engine Control & Immobilizer

ENGINE CONTROL AND ENGINE IMMOBILISER SYSTEM 80 SYSTEM OUTLINE The engine control system utilizes a microcomputer and maintains overall control of the engine, transmission etc. An outline of the engine control is given here. 1. INPUT SIGNALS (1) Engine coolant temp. signal circuit The engine coolant temp. sensor detects the engine coolant temp. and has a built–in thermistor with a resistance which varies according to the engine coolant temp. The engine coolant temp. is input into TERMINAL THW of the engine control module as a control signal. (2) Intake air temp. signal circuit The intake air temp.

sensor is installed in the mass air flow meter and detects the intake air temp., which is input as a control signal to TERMINAL THA of the engine control module. (3) Oxygen sensor signal circuit The oxygen density in the exhaust emission is detected and is input as a control signal from the heated oxygen sensors to TERMINALS OXL1, OXR1, OXL2, OXR2 of the engine control module. (4) RPM signal circuit The camshaft position is detected by the camshaft position sensor and is input into TERMINAL G2 of the engine control module as a control signal. Also, the engine RPM is detected by the crankshaft position sensor and the signal is input into TERMINAL NE+ of the engine control module.

(5) Throttle position sensor signal circuit The throttle position sensor detects the throttle valve opening angle as a control signal, which is input into TERMINAL VTA of the engine control module. (6) Vehicle speed circuit The vehicle speed sensor (Combination meter) detects the vehicle speed, and the signal is input into TERMINAL SPD of the engine control module via the combination meter. (7) Battery signal circuit Voltage is constantly applied to TERMINAL BATT of the engine control module. When the ignition SW is turned on, the voltage for engine control module start up power supply is applied through the EFI or ECD relay, to TERMINALS +B, +B1 of the engine control module.

The current from the IGN fuse flows to TERMINAL IGSW of the engine control module, and voltage is constantly applied to TERMINAL +BM. (8) Intake air volume signal circuit The intake air volume is detected by the mass air flow meter, and is input as a control signal to TERMINAL VG of the engine control module. (9) Stop light SW signal circuit The stop light SW is used to detect whether the vehicle is braking or not, and the signal is input into TERMINAL STP of the engine control module as a control signal.

(10)Starter signal circuit To confirm whether the engine is cranking, the voltage applied to the starter motor when the engine is cranking is detected, and is input into TERMINAL STA of the engine control module as a control signal. (11) Engine knock signal circuit Engine knocking is detected by the knock sensors, and is input into TERMINALS KNKL, KNKR of the engine control module as a control signal. SYSTEM OUTLINE